Refer to the sample below to check the print quality.
DCP-T520W/DCP-T525W
Patterns
Print Quality
None A Few About Half Many
DCP-T720DW/DCP-T725DW/DCP-T820DW/DCP-T825DW
Patterns
Print Quality
None A Few About Half Many
7. Do one of the following:
• If print head cleaning is needed, press Colour Start to start the cleaning procedure.
• If print head cleaning is not needed, press Stop/Exit to finish the Print Quality check.
8. After the cleaning procedure is finished, press a. Then, press Colour Start.
The machine prints the Print Quality Check Sheet again. Check the quality of the four colour blocks on the
sheet again.
If you clean the print head several times and the print has not improved, try the Special cleaning method. See
Related Information.
IMPORTANT
DO NOT touch the print head. Touching the print head may cause permanent damage and may void the print
head's warranty.
When a print head nozzle is clogged, the printed sample looks like this:
After the print head nozzle is cleaned, the horizontal lines are gone:
MFC-T920DW/MFC-T925DW
1. Press (Ink).
2. Press a or b to make your selections:
a. Select [Impr. PrintQuality]. Press OK.
b. Select [Impr. PrintQuality] again. Press OK.
421
To Next Page
Loading...
