Brother GT-3 Series - SAFETY INSTRUCTIONS; Safety Indications and Meanings; Notes on Safety

>
After performing the daily maintenance on the white ink,
a nozzle check should be printed to verify the print quality !
DAILY MAINTENANCE
If the printer has printed with white ink within the last eighteen hours...
18H
-
>
White Agitation
>
Shaking White Ink
The White ink contains titanium dioxide which helps provide vibrancy.
This will separate after being stationary for more than eighteen hours.
Dull prints will result if the ink is not agitated before use. Put the white ink cartridge
upside down and shake it side to side and tip end over end for 45-60 seconds.
> TIP
+
PHCNZC
&
If the printer has printed with white ink a minimum of 15 T-shirts the day
before...
minimum
If the printer has NOT printed with white ink a minimum of 15 T-shirts the
day before...
minimum
If the printer has NOT printed with white ink within the last eighteen hours
18H
+
Then the could be performed instead of
directly after the
SWI
minimum
>
WA
2
Firmware version 3.00 or higher
White Tube Flush
+
> No matter if you will have to do the or , you must BEFORE !
WA
SWI
WTF
SWI
Then the must be performed after the
minimum
>
WTF
WTF