Brother GTX Series - Page 11

Switch on the printer and insert a USB stick
Go to the menu: Maintenance > Log copy to USB >
OK
MENU
11
When the printer will not be used for a prolonged period of time, take appropriate proce-
dures before storing the printer depending on storage period or condition.
> DO NOT turn the printer OFF, otherwise, the printer may be damaged.
The printer can be used through normal procedure after the storage period, by perform-
ing the following maintenance tasks:
• Please empty the waste ink in the waste ink tank
• Check the amount of Cleaning Solution in the cleaning liquid tank, and rell the tank
when its amount is below the proper level.
• Stir the white ink if a white ink cartridge stirring message is displayed on the operation
panel screen.
• Print out a Nozzle Check pattern
When storing the printer for more than two weeks, cleaning of the Nozzle Guard, Wiper
and Exhaust Cap should be performed
Same procedure as above plus:
• If a non-ring nozzle is found, perform Head Cleaning and run the Nozzle Check pat-
tern print, and verify the result again.
> WITHIN 2 WEEKS
> FOR MORE THAN 2 WEEKS
WHEN NOT USING PRINTER FOR LONG PERIOD OF TIME
INK & SOLUTIONS STORAGE
HOW TO EXTRACT A LOG FILE FROM THE PRINTER?
CMYK & White inks, Cleaning Solution, Maintenance Solution &
Pretreatment Solution should be stored at a temperature range
between 0° and 40°
> Be carefull NOT to go below Zero degree !
0
MIN
STORAGE
TEMPERATURE
40
MAX
C
°
°
Menu > Maintenance > Maintenance Part Clean/Replace > and follow instructions on the display