> MAINTENANCE PARTS CLEANING & REPLACING PROCEDURES
In case of Warning/Error messages please follow the
following procedures:
> WIPER CLEANER REPLACEMENT
> FLUSHING FOAM REPLACEMENT
Lift up the ushing receivers and
place them on cleaning paper to
avoid dripping ink.
Remove Flushing Foams and clean
the holes of the receivers.
Install new Foams and put back the
receivers at their original location.
> FAN FILTER REPLACEMENT
Extract the 2 lter holders from the
back of the machine.
Mount a new Fan Filter in each black
frames.
Coarse mesh surface in direction of
the inner side of the printer and ne
mesh surface in direction of the out-
side of the printer.
Menu > Maintenance > Maintenance Part Clean/Replace > and follow instructions on the display
> Always use this menu to perform cleanings or replace parts :
OK
MENU
30
Min
1
2 3
WARNING ERROR
W
E
Simply remove the old Wiper Cleaner by lifting it up. Replace with a new one.
COARSE
AIR FLOW
FINE
MESH
OUTSIDE
MAINTENANCE PARTS EXCHANGE
9
To Next Page
Loading...
