Brother GTX - Heat Press Settings for Pre-Treatment Drying; Drying Pre-Treated Garments; Heat Press & Tunnel Dryer Settings for Ink Curing; Curing Printed Ink

35
Seconds
Pre
Treatment
1/2 distilled
water
75 - 80
180°C
35
Seconds
Pre
Treatment
1/2 distilled
water
PSI
180°C
35
Seconds
3,30
Minutes
Ink
Curing
10 - 20
PSI
180°C
160°C
320°F
35
Seconds
3:30
Minutes
Ink
Curing
Ink
Curing
180°C
10 - 20
PSI
TUNNEL DRYER
HEATPRESS
160°C
VERY IMPORTANT
The Brother GTX should ALWAYS be left with the Power ON
NEVER shut OFF the printer unless instructed to by the display panel. Power
is required to perform the white Ink recirculation from time to time.
In the event that the power goes out
or your printer has an error during
printing, push the Carriage back all
the way to the left to dock it and use
the Fixing Pin to lock it in place.
HEAT PRESS SETTINGS for Pre-Treatment DRYING
HEATPRESS & TUNNEL DRYER SETTINGS for INK CURING
Check the Real Temperature with a Probe or with Strips to be sure that you are safe for washability
Use a Silicon sheet on the heat press to cover the pre-treatment and clean the surface every 5 T-shirts
POWER
NEVER POWER OFF THE PRINTER!
3
You can also use Parchment paper when curing the Pre-treatment in order to minimise the need to clean off
the covers and to avoid issues with bers standing up on the garment
Watch the Video: Using and Storing the CR Holding Pin