10
Setting Up Your Printer
Do NOT connect the interface cable.
Connecting the interface cable is
done when installing the driver.
1
Make sure that the printer power switch is
off.
Connect the AC power cord to the printer.
2
Plug the AC power cord into an AC outlet.
Turn the power switch on.
3
After the printer has finished warming up,
the Status LED stops blinking and stays
green.
4
Press the Go button. The printer prints a
test page.
Check that the test page has printed
correctly.
4 Print a Test Page
Extend the
Support flap.
Go to the next page
to install the driver.
Step 1
To Next Page
Loading...
