To Next Page

To Previous Page

CHAPTER 6 EPSON - 22

Select international character set

EscRn (27)(82)n <1Bh><52h>n

 This command selects one of the available international character sets, refer to the printer User Guide for

supported character sets.

 Each character set varies slightly from the others and contains a small number of special characters necessary

for printing in that particular language.

 The selection you make with this command does not affect any italic or graphics character table selection that

you may have made with the Esc t command.

 The character sets listed below, plus several others, can also be selected from the printer's control panel.

 The character sets available and the corresponding values of n are as follows:

US ASCII 0 Japanese 8

French I 1 Norwegian 9

German 2 Danish II 10

UK ASCII I 3 UK ASCII II 13

Danish I 4 French II 14

Swedish 5 Dutch 15

Italy 6 South African 16

Spanish 7

 If you have selected the graphics character table with the Esc t 1 command the following additional character

sets are available.

Norwegian set I 17 IBM set I 19

Norwegian set II 18 IBM set II 20

LPRINT CHR$(27); CHR$(82); CHR$(3); 'Select British char set

Select italic / graphics character table

Esctn (27)(116)n <1Bh><74h>n

 This command allows you to choose between two character tables - the italic character table and the graphics

character table.

 The two tables are shown in the Epson FX-850 section of the appendix at the end of this manual.



Set n to 0 to select the italic character table. Character codes in the range 160 to 255 are now italic

characters.

 Set n to 1 to select the extended character table. Character codes in the range 128 to 255 are now foreign

language and graphics characters.

 You can still print italic characters using the Select Italic Mode, Esc 4, command even when you have

selected the graphics character table.

Brother HL-5280DW User Manual

Other manuals for Brother HL-5280DW