A - 7 APPENDIXES
5
Unpack the DIMM and hold it by its edges.
6
Hold the DIMM with your fingers on the side edges and
your thumb on the back edge. Line up the notches on the
DIMM with the DIMM slot. (Check that the locks on each
side of the DIMM slot are open or facing outwards.)
7
Press the DIMM straight into the slot (press firmly). Make
sure the locks on each side of the DIMM click into place.
(To remove a DIMM, you must release the locks.)
8
Secure the metal plate with the two screws.
9
Put the side cover back on.
10
Reconnect the interface cable to your printer.
Plug the printer back in, and then turn on the printer power switch.
11
To check whether the DIMM has been installed properly, you can print the Print Settings listing that
shows the current memory size.
To set the memory size, see How to Set the RAMDISK size on page 4-4.
To Next Page
Loading...
