Unpack the machine and check the components
Read the Product Safety Guide first, then read this Quick Setup Guide for the
correct installation procedure.
NOTE:
•The components included in the box and the AC power plug may differ
depending on your country.
•The available connection interfaces vary depending on the model.
•The illustrations in this Quick Setup Guide are based on the HL‑1210W or
HL‑1212W.
•You must purchase the correct interface cable for the interface you want to use.
USB cable
We recommend using a USB 2.0 cable (Type A/B) that is no more than
2 metres (6 feet) long.
Remove the packing materials and install the toner cartridge
Load paper in the paper tray
Connect the machine to your computer/mobile device
Connect the power cord and turn on the machine
Inbox/Starter Toner Cartridge
A5 Long Edge Paper Input
Support
CD‑ROM
3
2
4
1
• Windows
®
PC with a CD‑ROM drive, go to step 4A
• Windows
®
PC without a CD‑ROM drive, go to step 4B
• Macintosh, go to step 4B
• Mobile device users with a WPS/AOSS™‑supported access point/router, go to step 4C
Back Front
POWER OFF READY
SLEEP
DEEP SLEEP
WARMING UP
COOLING DOWN
RECEIVING DATA
DATA REMAINING
TONER LOW REPLACE TONER PAPER JAM
DRUM END SOON
REPLACE DRUM
Dimmed 1 second interval 0.5 second interval
Printer LED Indications
Blinking: or ON: OFF:
Adjust the paper guides to fit
the paper being used.
To use A5 Long Edge paper.
Quick Setup Guide
HL‑1210W(E) / HL‑1211W / HL‑1212W
Not all models are available in all countries.
The latest manuals are available at the Brother
Solutions Center: solutions.brother.com/manuals.
Watch our FAQ Videos for help
with setting up your Brother
machine:
solutions.brother.com/videos.
Version 0
ENG
To Next Page
Need help?
General