General information
15
1
1.Setup
Receive
(In FAX mode
only)
(Continued)
5.Memory
Receive
(Continued)
Off Further incoming
faxes will not be
stored in memory.
The machine will
then stop
automatically
answering calls until
fresh paper is put in
the paper tray. To
print the last fax you
received, put fresh
paper in the tray and
press Start.
6.Print
Density
You can adjust the
Print Density setting
to make your printed
pages darker or
lighter.
-nnnno+
-nnnon+
-nnonn+*
-nonnn+
-onnnn+
Press c to make
darker, press d to
make lighter.
2.Setup Send 1.Contrast Changes the
lightness or darkness
of faxes you send.
Auto* Auto will give the
best results. It
automatically
chooses a suitable
contrast for your
document.
Light If your document is
too light, choose
Light.
Dark If your document is
too dark, choose
Dark.
2.Fax
Resolution
Sets the default
resolution for
outgoing faxes.
The quality of an
outgoing fax can be
improved by
changing the Fax
Resolution.
Standard* Suitable for most
typed documents.
Fine Good for small print
and transmits a little
slower than Standard
resolution.
S.Fine Good for small print
or artwork and
transmits slower than
Fine resolution.
Photo Use when the
document has
varying shades of
grey or is a
photograph. This has
the slowest
transmission time.
2.Fax (continued)
Level 2 Level 3 Descriptions 1 Options Descriptions 2 Page
The factory settings are shown in Bold with an asterisk.
To Next Page
Loading...
Need help?
General