Brother MFC-660CN - Erasing Incoming Messages; Additional TAD Operations; Setting Maximum Time for Incoming Messages

Digital TAD (MFC-660CN only)
65
9
Erasing incoming messages 9
To erase voice messages individually9
a Press Play/Record.
The machine will sound a two second
beep and begins message playback.
Each message is preceded by one long
beep, and followed by two short beeps.
b To erase a specific message, press
Erase/Mute immediately after the two
short beeps, or while the message is
playing.
c Do one of the following:
 Press 1 to erase the message.
 Press 2 to cancel.
d Press Stop/Exit.
To erase all of your messages 9
a Press Erase/Mute.
b Do one of the following:
 Press 1 to erase all of your voice
messages.
 Press 2 to cancel.
c Press Stop/Exit.
Additional TAD
operations 9
Setting maximum time for
incoming messages 9
Your machine’s default setting will save
incoming messages up to 30 seconds long.
To change this setting follow the steps below:
a Press Menu.
b Press a or b to choose Fax.
Press OK.
c Press a or b to choose Setup TAD.
Press OK.
d Press a or b to choose ICM Max.
Time.
Press OK.
e Press a or b to choose the maximum
time setting for incoming messages (30,
60, 120 or 180 seconds).
Press OK.
f Press Stop/Exit.