Brother MFC-7860DW

30
For Wireless Network Users
One push configuration using Wi-Fi Protected Setup or AOSS™
(Windows
®
and Macintosh)
19
Configure the wireless
settings
a Confirm your WLAN access point/router has
the Wi-Fi Protected Setup or AOSS™ symbol
as shown below.
b Place the Brother machine within range of your
Wi-Fi Protected Setup or AOSS™ access
point/router. The range may differ depending
on your environment. Refer to the instructions
provided with your access point/router.
c On your machine, press Menu, 6 (Network),
2 (WLAN), 3 (WPS/AOSS).
When WLAN Enable ? is displayed, press 1
to choose On. This will start the wireless setup
wizard.
Otherwise press Stop/Exit to exit from the
wireless setup wizard.
When Start WPS/AOSS on your
wireless access point/router.
appears, press the Wi-Fi Protected Setup or
AOSS™ button on your wireless access
point/router. See the user’s guide for your
wireless access point/router for instructions.
And then press OK.
This feature will automatically detect which
mode (Wi-Fi Protected Setup or AOSS™) your
access point/router uses to configure your
machine.
d A connection result message appears on the
LCD and a WLAN report will automatically be
printed.
If the connection failed, check the error code on
the printed report and refer to
Troubleshooting on page 31.
To install the MFL-Pro Suite, continue to
step 20.
For Windows
®
Users:
Now go to
page 35
For Macintosh Users:
Now go to
page 37
Note
If your wireless access point/router supports
Wi-Fi Protected Setup (PIN Method) and you
want to configure your machine using the PIN
(Personal Identification Number) Method, see
Using the PIN Method of Wi-Fi Protected Setup in
the Network User's Guide.
Wireless setup is now complete. A four
level indicator at the right of your
machine’s LCD will show the wireless
signal strength of your access
point/router.