(Models with the fax function only)
To reduce the risk of fire, electrical shock, and injury to people;
• Use only a No. 26 AWG or larger telecommunication line cord.
Disconnect device
This product must be installed near an AC power outlet that is easily accessible. In case of an
emergency, you must unplug the power cord from the AC power outlet to shut off the power
completely.
For protection against the risk of electrical shock, always disconnect all cables from the wall
outlet before the equipment is installed, serviced, or modified.
IMPORTANT
• This product has been certified to comply with FCC standards, which are applied to the USA
only.
• This equipment may not be used on coin service lines provided by the telephone company
or connected to party lines.
• Brother cannot accept any financial or other responsibilities that may be the result of your
use of this information, including direct, special, or consequential damages. There are no
warranties extended or granted by this document.
• A grounded plug should be plugged into a grounded AC power outlet after checking the
rating of the local power supply for the product to operate properly and safely.
Standard Telephone and FCC Notices (Models with the fax
function only)
These notices are in effect on models sold and used in the United States only.
When programming emergency numbers or making test calls to emergency numbers:
• Remain on the line and briefly explain to the dispatcher the reason for the call before
hanging up.
• Perform these activities in the off-peak hours, such as early morning or late evening.
This equipment complies with Part 68 of the FCC rules and the requirements adopted by the
ACTA. On the back side of this equipment is a label that contains, among other information, a
product identifier in the format US: AAAEQ##TXXXX. If requested, this number must be
provided to the telephone company.
14
To Next Page
Loading...
Need help?
General
Weight and Dimensions
