You may safely connect this equipment to the telephone line by means of a standard modular
jack, USOC RJ11C.
A plug and jack used to connect this equipment to the premises wiring and telephone network
must comply with the applicable FCC Part 68 rules and requirements adopted by the ACTA. A
compliant telephone cord and modular plug is provided with this product. It is designed to be
connected to a compatible modular jack that is also compliant. See installation instructions for
details.
The Ringer Equivalence Number (REN) is used to determine the number of devices that may be
connected to a telephone line. Excessive RENs on a telephone line may result in the devices
not ringing in response to an incoming call. In most but not all areas, the sum of RENs should
not exceed five (5.0). To be certain of the number of devices that may be connected to a line, as
determined by the total RENs, contact the local telephone company. For products approved
after July 23, 2001, the REN for this product is part of the product identifier that has the format
US:AAAEQ##TXXXX. The digits represented by ## are the REN without a decimal point (e.g.,
06 is a REN of 0.6). For earlier products, the REN is separately shown on the label.
If this equipment causes harm to the telephone network, the telephone company will notify you
in advance that temporary discontinuance of service may be required. But if advance notice is
not practical, the telephone company will notify you as soon as possible. Also, you will be
advised of your right to file a complaint with the FCC if you believe it is necessary.
The telephone company may make changes in its facilities, equipment, operations, or
procedures that could affect the operation of the equipment. If this happens, the telephone
company will provide advance notice in order for you to make necessary modifications to
maintain uninterrupted service.
If trouble is experienced with this equipment, for repair or warranty information, contact Brother
Customer Service (see the Online User's Guide: Brother Help and Customer Support). If the
equipment is causing harm to the telephone network, the telephone company may request that
you disconnect the equipment until the problem is resolved.
Connection to party line service is subject to state tariffs. Contact the state public utility
commission, public service commission or corporation commission for information.
If your home has specially wired alarm equipment connected to the telephone line, ensure the
installation of this equipment does not disable your alarm equipment. If you have questions
about what will disable the alarm equipment, call your telephone company or a qualified
installer.
The Telephone Consumer Protection Act of 1991 makes it unlawful for any person to use a
computer or electronic device to send any message via a telephone fax machine unless such
messages clearly contain, in a margin at the top or bottom of each transmitted page, or on the
first page of the transmission, the date and time it is sent and an identification of the business or
other entity or other individual sending the message and the telephone number of the sending
machine or such business, other entity or individual. To program this information into your
machine, see the Online User's Guide: Set the Date and Time and Set Your Station ID.
If you are not able to solve a problem with your product, contact Brother Customer Service (see
the Online User's Guide: Brother Help and Customer Support).
Federal Communications Commission (FCC) supplier's
Declaration of Conformity (USA Only)
Responsible Party:
Brother International Corporation
15
To Next Page
Loading...
Need help?
General
Weight and Dimensions
