Confidential
9.46 CR Encoder Strip...............................................................................................3-117
9.47 Carriage Motor...................................................................................................3-118
9.48 Flushing Base....................................................................................................3-121
9.49 LT Frame ASSY (T2 Paper Pull-in Roller L/R) ..................................................3-122
9.50 T2 Bank ASSY...................................................................................................3-126
9.51 Power Supply PCB ASSY .................................................................................3-127
9.52 Switchback Roller..............................................................................................3-129
9.53 PF Encoder Disk................................................................................................3-130
9.54 PF Encoder Sensor PCB...................................................................................3-131
9.55 Paper Feed Motor..............................................................................................3-133
9.56 Paper Feed Roller .............................................................................................3-135
9.57 Platen/Paper Ejection Roller..............................................................................3-136
9.58 Registration Sensor PCB...................................................................................3-139
9.59 Flushing Box......................................................................................................3-142
9.60 Paper Feed Arm Frame ASSY (T1 Paper Pull-in Roller L/R)............................3-142
9.61 T1 Bank ASSY...................................................................................................3-144
9.62 T1 Base Pad / T2 Base Pad / T3 Base Pad......................................................3-146
9.63 3rd Tray Relay PCB...........................................................................................3-147
9.64 3rd Tray Paper Pull-in Sensor PCB...................................................................3-148
9.65 Intermediate Roller............................................................................................3-149
9.66 3rd Tray Paper Feed Motor...............................................................................3-149
9.67 T3 Bank ASSY...................................................................................................3-153
9.68 T3 Paper Pull-in Roller L/R................................................................................3-155
CHAPTER 4 ADJUSTMENTS AND UPDATING OF SETTINGS,
REQUIRED AFTER PARTS REPLACEMENT..............................................4-1
1 IF YOU REPLACE THE MAIN PCB...............................................................................4-1
1.1 Customize destinations (Maintenance mode 74) ..................................................4-3
1.2 < Except for Printer model > Set the CIS type (Maintenance mode 59)................4-3
1.3 Install the firmware (Maintenance mode 28) .........................................................4-3
1.4 Initialize the EEPROM parameters (Maintenance mode 01).................................4-5
1.5 Restore the head calibration data (Maintenance mode 68)...................................4-5
1.6 Set the serial number (Maintenance mode 80) .....................................................4-5
1.7 Updating of head property information (Maintenance mode 68) ...........................4-6
1.8 Restore machine information (Maintenance mode 46)..........................................4-6
1.9 Adjust the touch panel (Maintenance mode 78)....................................................4-7
1.10 < Except for Printer model > Acquire white/black level data
(Maintenance mode 55).........................................................................................4-7
1.11 Adjustment of software correction for inclination/corrugation/ruled lines
(Maintenance mode 65 / User menu)....................................................................4-7