Brother Network - Gateway; Node Name; WINS Config

Control panel setup
23
3
a Press Menu.
b Press a or b to choose Network.
Press OK.
c Press a or b to choose TCP/IP.
Press OK.
d Press a or b to choose Gateway.
Press OK.
e Enter the Gateway address using the dial pad. (To enter numbers and text, see Entering Text
on page 138.)
Press OK.
f Press Stop/Exit.
Node Name 3
You can register the machine name on the Network. This name is often referred to as a NetBIOS name; it will
be the name that is registered by the WINS server on your network. Brother recommends the name
“BRNxxxxxxxxxxxx”. (“xxxxxxxxxxxx” is your machine’s MAC Address / Ethernet Address.)
a Press Menu.
b Press a or b to choose Network.
Press OK.
c Press a or b to choose TCP/IP.
Press OK.
d Press a or b to choose Node Name.
Press OK.
e Press 1 to choose Change.
f Enter the Node Name using the dial pad. (To enter numbers and text, see Entering Text on page 138.)
Press OK.
g Press Stop/Exit.
WINS Config 3
This selection controls how the machine obtains the IP address of the WINS server.
a Press Menu.
b Press a or b to choose Network.
Press OK.
c Press a or b to choose TCP/IP.
Press OK.