Brother PE-DESIGN V7 - Page 165

159
Arranging Embroidery Designs (Layout & Editing)
Motif stitch
Motif
Selects whether to use pattern 1 or pattern 2 for the motif stitch. If you choose to use both patterns, the data
is created to sew alternating rows of the two.
Pattern1 only: Uses only pattern 1 (Default)
Pattern2 only: Uses only pattern 2
Pattern1 and 2: Uses pattern 1 and pattern 2
Pattern1
Pattern2
Select a pattern for the motif stitch.
Click , and then, in the Browse dialog box that appeared, select the
folder containing the .pmf file that you want to use. Double-click the desired
pattern, or select it, and then click OK.
Width
(horizontal
length)
Sets the motif pattern width (the direction along the line).
Range: 2.0–100.0 mm (0.08–3.94 inches)
Default: 5.0 mm (0.20 inch)
Height
(vertical
length)
Sets the motif pattern height (the direction perpendicular to the line).
Range: 2.0–100.0 mm (0.08–3.94 inches)
Default: 5.0 mm (0.20 inch)
H-Arrange
(horizontal
arrangement)
Sets the horizontal arrangement of the motif pattern.
For patterns like , the patterns will be arranged
along the line as shown at the right.
V-Arrange
(vertical
arrangement)
Sets the vertical arrangement of the motif pattern.
For patterns like , the patterns will be arranged
along the line as shown at the right.
H-Spacing
(horizontal
spacing)
Sets the horizontal spacing (the direction along the
line) of motif patterns.
Minimum: Depending on the pattern
A negative value can be specified.
Maximum: 100.0 mm (3.94 inches)
Default: 0.0 mm
V-Spacing
(vertical
spacing)
Sets the vertical spacing (the direction
perpendicular to the line) of motif patterns.
Minimum: Depending on the pattern
A negative value can be specified.
Maximum: 100.0 mm (3.94 inches)
Default: 0.0 mm
Direction
Allows you to rotate the angle of the motif stitch.
This setting can be specified for patterns other than
manual punching patterns.
Range: 0–359 degrees
Default: 0 degrees
Row Offset
Sets the amount of offset for each row.
Range: 0.0–10.0 mm (0.00–0.39 inch)
Default: 0.0 mm (0.00 inch)
Run Pitch
Sets the pitch of the sewing.
Range: 1.0–10.0 mm (0.04–0.39 inch)
Default: 10.0 mm (0.39 inch)
Normal:
Mirror:
Alternate:
Normal:
Mirror:
Alternate:
H-Spacing:
V-Spacing:
0°
45°
90°
135°
180°
225°
270°
315°