243
Creating Custom Fonts (Font Creator)
5. After clicking point 4 (the last point of the
block-type pattern), click (running-type
pattern button), and then in the Design Page
to specify point 5 through 7.
6. Click (straight block-type pattern), and
then click in the Design Page to specify points
8 through 10 as shown in the illustration
below.
7. Click .
8. Click , and then click in the Design Page
to specify points 11 through 12.
9. To complete the pattern, double-click point 13
(the last point of the entire pattern).
6
7
5
8
9
10
11
12
b Memo:
• When entering points, change the punch
type by pressing the appropriate shortcut
key.
• A template image is needed in order to use
the semi-automatic block-type punch tool. If
there is no image, this tool will create a
punching pattern like the straight block-type
punch tool.
• Once the pattern is drawn, you can still
transform straight block-type patterns into
curved block-type patterns and vice versa.
For details, refer to “Editing points” on
page 249.
13
To Next Page
Loading...
