43
Tutorial
Insert an original card into the USB card
writer module.
Transfer the embroidery pattern.
Click File, then Write to Card.
→ The following message appears.
Click OK.
→ The following message appears.
Click OK.
Quit Layout & Editing.
Click File, then Exit.
a Note:
The original card is inserted correctly when
you hear it snap into place.
2
3
a Note:
Before using the original card, make sure
that the designs on the card are no longer
needed or make sure to store them on your
hard drive or other storage media.
a Note:
• If the card writer module is not correctly
connected or powered, an error message
of “No card writer module is connected.
Please connect card writer module.” will
appear.
• If the original card is not inserted or is
defective, an error message of “No
original card is inserted. Please insert an
original card.” will appear.
b Memo:
In Layout & Editing, the pattern is saved as a
.pes file.
To save the pattern, click
File
in Layout &
Editing, then
Save as
.
4
To Next Page
Loading...
