Brother PJ-723 - Page 77

Changing the Printer Settings
69
3
Advanced Tab 3
1 Roll Printer Case Setting
Specifies the setting for using the optional roll printer case. If [On] is selected, you can adjust the feed
value or amount of paper retraction for the roll printer case.
Available settings: [On], [On (Without Anti Curl)], [On (Short Feed)], [Off]
2 Print Length Scaling
Specifies the reduction or enlargement ratio for printing.
Available settings: 95% - 105% (in increments of 0.5%)
3 Form Feed Mode
Specifies how the printer responds to form feed commands received from any source.
Available settings: [No Feed], [Fixed Page], [End of Page], [End of Page Retract]
For more information on the options, see Settings That Can Be Changed Using the Windows
®
Printer
Driver (Examples) on page 32.
4 Paper Grip Time
Specifies the delay before the printer grabs the paper.
Available settings: [0.5 seconds], [0.8 seconds], [1.2 seconds]
5Pre-Feed
If [Enable] is selected, the printer ejects a short length of paper when the printer turns on. When using
perforated roll paper or roll paper that is pre-printed, we recommend setting this parameter to [Disable].
Available settings: [Enable], [Disable]
6 Paper Sensor Threshold
Specifies the threshold of the paper detection sensor.
Available settings: 0-255
7 Print Data after Printing
Allows to erase print data after it is printed.
Available settings: [Erase All Print Data], [Keep Print Data]
1
2
3
4
5
6
7
8
9
10
11