34
Inspections and Maintenance
IGNITION COILS
Ignition Coil Removal
1) Disconnect ignition coil connector.
IMPORTANT: Twist ignition coil in both direc-
tions as you pull it up to ease removal.
2) Remove ignition coil from spark plug.
Ignition Coil Lubrication
1) Pull rubber seal down.
2) Apply Dow Corning 111, P/N 460796, or
equivalent to rubber seal seat as shown.
3) Pull rubber seal back on its seat making
sure the tabs on the ignition coil and the
slots in the seal properly match together.
4) Leave a ring of grease on top of the seal as
shown to act as a water barrier. Wipe off
the excess.
5) Apply DOW CORNING 111, P/N 460796,
or equivalent on rubber seal contact area.
Ignition Coil Installation
IMPORTANT: Prior to inserting the ignition
coil on its spark plug, apply sealant as de-
scribed in IGNITION COIL LUBRICATION
1) Install coil in cylinder head hole.
2) Push the ignition coil down to securely in-
stall it on the spark plug tip.
NOTICE
Do not remove the ignition coil before
disconnecting the input connector or the
wires may be damaged. Do not pry up
ignition coil with a screwdriver to avoid
damage.
1. Rubber seal pulled down
sbs2009-011-002
1. Apply product here
sbs2009-011-001
1. Correctly shaped excess of
pr
oduct
sbs2009-011-003
1. Apply product here
smr05-015-002_d3
To Next Page
Loading...
Need help?
General
