29
ROTAX JET PROPULSION PERIODIC MAINTENCANCE SCHEDULE
A: ADJUST
C: CLEAN
I: INSPECT
L: LUBRICATE
R: REPLACE
RS: REPAIR SHOP
O: OPERATOR
(1) At storage period or after 100 hours of use
whichever comes first.
(2) Replace at 200 hours of use, irrespective of the
number of years.
(3) Spray an anti-corrosion lubricant on metallic
components in engine compartment.
(4) Every 10 hours in salt water.
(5) Daily flushing in salt water or foul water use.
(6) Replace if required.
(7) Lubricate for corrosion protection.
(8) Inspect each month (every two weeks in salt)
and change when necessary
TO BE PERFORMED BY
EVERY 200 HOURS OR 2 YEARS
EVERY 100 HOURS OR PRE-SEASON
FIRST 25 HOURS
PART / TASK
ENGINE
Engine oil and filter RR (1) RS
Rubber mounts
II O, RS
Corrosion protection (3)
L (4) O
EXHAUST SYSTEM
Exhaust system (including hoses, fasteners,
components and leaks)
II, C (5) O, RS
Exhaust system flushing
I, C (1) O
COOLING SYSTEM
Hose and fasteners II O, RS
Coolant I RO, RS
FUEL SYSTEM
Throttle body II O, RS
Fuel lines, connections, pressure relief valve and
fuel system leak test
II RS
ENGINE MANAGEMENT SYSTEM
Fault codes II I
AIR INTAKE SYSTEM
Air filter I (6) RS
To Next Page
Loading...
Need help?
General
