BRP ROTAX 916 i A Series - Wastegate and PCV Check; Engine Instruments Check - Wastegate;PCV; Set Throttle Valve to WOT; Deactivate ECU Lane A for Wastegate Check

BRP-Rotax
MAINTENANCE MANUAL LINE
Points of Inspection
Interval Operating hours Chapter
Reference
Signa-
ture
* no periodic maintenance (re-
quirement after the first 25 hours
of operation)
25* 50 100 200 400 600 1000
3) Spark plug
Check that spark plug connectors fit
tightly on the spark plugs. Minimum
pull-off force is 30 N (7 lb).
X 12–20–00
Inspection of
spark plugs
Remove all spark plugs and check
for spark plug defects (deposits,
melting,...). Check if GENUINE-RO-
TAX®- spark plugs are used.
X X 12–20–00
Remove the
spark plugs
Replacing spark plugs.
(2
use of leaded fuel (AVGAS) more
than 30% of operation
X
(2
X 12–20–00
Installation
of spark
plug
4) Inspecting the magnetic plug
Check the magnetic plug.
X X 12–20–00
Inspecting
the mag-
netic plug
5) Inspecting the oil filter
Remove oil filter from engine. Cut
old filter without producing any metal
chips and inspect following compo-
nents for wear and/or missing
material.
Filter mat:
Findings:
____________________________-
________
X
(3
X 12–20–00
Inspection of
the oil filter
components
(3
use of leaded fuel more than 30% of operation
6) Visual inspection of the engine
General visual inspection of the en-
gine for damage or abnormalities.
Check cooling air duct and cooling
fins of the cylinders for obstruction,
cracks, wear and good condition.
Take note of changes caused by
temperature influence.
X X 12–20–00
Visual
inspection
Effectivity: 916 i A / C24
Edition 0/Rev. 1
05–20–00
Page 9
December 01 2023