BRP ROTAX 916 i A Series - Lane and Wastegate Checks; Engine Instruments Check - Lane A;B; Activate ECU Lane A for Wastegate Check; Warning Indicator A Check - Wastegate;PCV

BRP-Rotax
MAINTENANCE MANUAL LINE
Points of Inspection
Interval Operating hours Chapter
Reference
Signa-
ture
* no periodic maintenance (re-
quirement after the first 25 hours
of operation)
25* 50 100 200 400 600 1000
Inspect temperature sensors and oil
pressure sensor for secure fit and
signs of wear.
X
Inspect all coolant hoses of the en-
gine for damage, including leakage,
hardening from heat, porosity, loose
connections and secure attachment.
Verify routing is free of kinks and
restrictions.
X X 12–20–00
Leakage
check
Carry out visual inspection of leak-
age bore at the base of the water
pump for signs of leakage.
X X 12–20–00
Leakage
check
Check steel fuel rails and lines for
any cracks and/or scuffing marks.
X X 12–20–00
Checking
the fuel lines
Inspect the wiring (wiring harness)
and its connections for secure fit,
damage and signs of wear.
X X 12–20–00
Check of
wiring
Check the airbox (GENUINE RO-
TAX® part) incl. throttle body actua-
tion. Inspect sensors for tight fit,
damage from heat, damage and
signs of wear.
X X
Inspection of the GENUINE RO-
TAX® exhaust system included in
the standard delivery.
NOTE
If there is no GENUINE ROTAX®
exhaust system in use, the speci-
fications of the manufacturer
must be observed.
X
05–20–00
Page 10
December 01 2023
Effectivity: 916 i A / C24
Edition 0/Rev. 1