BRP-Rotax
MAINTENANCE MANUAL LINE
Points of Inspection
Interval Operating hours Chapter
Reference
Signa-
ture
* no periodic maintenance (re-
quirement after the first 25 hours
of operation)
25* 50 100 200 400 600 1000
Inspect radiator cap. Inspect protec-
tion rubber on expansion tank base
for correct fit.
tank, radia-
tor cap
Flushing the cooling system if mas-
sive deposits on the expansion tank
or radiator cap and/or if the coolant
manufacturer required an change
interval.
when replacing the coolant 12–20–00
Flushing the
cooling
system
14) Engine cleaning
Engine cleaning. X X 12–20–20
Engine
cleaning
15) Pre-engine test run – Liquid level check
Verify liquid level, replenish as
necessary.
X X 12–10–00
Fluid
capacities
16) Checking the pop-off valve
Check the pop-off valve for 700 mbar
/ 10.15 PSI low-pressure and its full
opening.
X 12–20–00
Check pop
off valve
17) Engine test run
Observe the safety instructions!
Start the engine and run to operating
temperature.
Limits see Operators Manual 916 i A
Series.
LANE check at _____ rpm engine
speed. Speed drop without LANE:
A (Off)___________rpm
B (Off)___________rpm
A/B (difference)________rpm
X X 12–20–00
Test run of
engine
Effectivity: 916 i A / C24
Edition 0/Rev. 1
05–20–00
Page 13
December 01 2023
To Next Page
Loading...
