5
B. VIBE COMMUNICATION SYSTEM
1. ANATOMY OF THE VIBE
BRP recommends avoiding any accessory covering your ears as this
may impair your capacity to clearly ear important surrounding noises.
BRP recommends that you always find out about the local road safety
rules regarding helmets equipped with a noise control system and/or a
communication system. Always abide to applicable
laws and
regulations where vehicle is driven.
2. VIBE INSTALLATION (HELMET PREPARATION)
REMOVING THE NECK CURTAIN
1. Place your helmet upside down on a
flat surface on the included inflatable
holder.
2. The neck curtain is attached on the
side portion by 3 “snaps” on each side.
Start from the front of the helmet and
gently pull on the neck curtain, toward
the center of the helmet.
3. Slide out the neck curtain from the
rear helmet portion. To fully remove the
protective collar, pull gently on the rear
neck portion, toward the center of the
helmet.
REMOVING THE CHEEK PADS
4. With the face shield in the open
position, detach the Velcro and the 3
snaps by pulling the right cheek pad
towards the inside of the helmet.
Inflatable Holder Not Shown
To Next Page
Loading...