10
UNIT DAMAGE HAZARD
Failure to follow this caution may result in equipment damage or
improper operation.
Improper wiring or installation may damage AC/HP Control. Check
to make sure wiring is correct before proceeding with installation or
turning on power.
CAUTION
!
1. Turn off all power to equipment.
2. If an existing thermostat is being replaced
a. Remove existing thermostat from wall.
b. Disconnect wires from existing thermostat, 1 at a time.
c. As each wire is disconnected, record wire color and terminal marking.
d. Discard o r recycle old thermostat.
ENVIRONMENTAL HAZARD
Failure to follow this caution may result in environmental damage.
Mercury is a hazardous waste. Federal regulations require that Mercury
be disposed of properly.
CAUTION
!
To Next Page
Loading...
