Bryston 11B - Page 6

Assembly Notes
for
11B/12B Preamps with Balanced Outputs
Component placement for Balanced Output 11B/12B Preamps
Hookup for Balanced Output board and XLR board
Foil side view
5 CONDUCTOR CABLE
□ bosaaol
2XLR-M I
REV 1 MAY S 9 I
- Cuz z> ii
- f agg > - ( agg >
- C»I6Nl|> <»16N)|>
-TaosQ-
si Cpop 1 (
fey V
JS' xiTfcoi x —
5L -<^f>
^ {iaas) ,
qno- ;
° <2°D> o
bryston - dgsp
BAL0UT2v2 C
a a
< agg > < azz >
< aec >
<H6Nl|> {>16Nl|>
-(aoet> /
SJ f
J°y xv/ytoi \
-<s> £ -<^Ni[>
GbOS?
s <3D>® <g5T>
1> Assemble Balanced Output Board (BALOUT 2v2)
2> Five conductor cable is prepared and soldered on to balanced output
board.
3> Install balanced output board on mother (main) board.
4-> Feed five conductor cable through hole in power supply shield and
soldered onto 2XLR—M board.
5> Insert male XLR jacks through power supply shield (from outside) &
solder on to 2XLR—M board.
XLR jacks are NOT screwed down; they will be sandwiched between
the main board, the chassis rear panel and the top panel and thus
held sucurely without any need for screws.
6> Apply self-ahesive label to outside surface of rear panel over XLR jacks
Component side view
12B-BAL WRP JULY 89