Source Selection: Accomodates 11 sources, up to 4
of which may be digital inputs
Digital Inputs: 4 coaxial
S/PDIF (RCA), 2 of which
may be assigned to optical
S/PDIF (TOSLINK)
Digital Inputs (Pro model): 1
AES/EBU, 4 coaxial
S/PDIF (RCA)
Stereo Analog Inputs: 6 stereo pairs (
RCA)
Discrete 5.1 Analog Inputs: 6 unbalanced (
RCA) for
Left, Centre, Right, Right Surround, Left Surround,
and Subwoofer
Main Audio Outputs: 6 unbalanced (
RCA) and 6 bal-
anced (
XLR) for Left, Right, Centre, Right Surround,
Left Surround, and Subwoofer
Additional Outputs for
ES/EX 6.1/7.1: Left Rear, Right
Rear (
RCA)
Audio Record Outputs: 2 stereo (
RCA) pairs from any
analog input
Frequency Response: 20Hz to 20kHz +/- 0.25 dB
THD
& Noise (20Hz to 20kHz at 3V output level): Less
than 0.006% in all modes; below 0.0025% in Bypass
mode.
Signal-to-Noise Ratio: Not less less than 100dB in all
modes; 110dB in Analogue Bypass Mode (Ref. 1V
input, maximum gain, 22kHz bandwidth).
Input Level: maximum 2 Vrms in DSP modes, 4Vrms
in Bypass Mode
Output Level: 8 Vrms (16 Vrms Balanced) in DSP
Modes; 10 Vrms (20 Vrms Balanced) in Bypass Mode
Output Impedance: 110 Ohms
D/A, A/D Conversion: Crystal Semiconductor 24-Bit
Delta-Sigma
DSP Engine: Motorola
Bass Management: 2nd Order high-pass filter (x5),
4th Order low-pass filter; Crossover Frequencies 60,
70, 80, 90, 100, 110, or 120 Hz
Display:Two-line, 16-alphanumeric characters per
line, black-on-green
Trigger Outputs: One 12
V on/off trigger; one 12
V
programmable
Power Requirements: 100
VAC, 115VAC, and
230
VAC models
Remote Functions: Power, master volume, source
switching, mode switching, mute, and trims (in test
mode)
Control Port: RS-232 (bidirectional, D9 connector)
port for integration of external control systems (
AMX,
Crestron, and others using character-based proto-
cols), and for control of external video switchers
Aux. Infrared Receiver Input: Mini-phone jack
XLR
Configuration: Pin 1 ground, pin 2 positive, pin
3 negative
Front Panel: Silver or Black; 17”-wide for shelf
mounting or 19” rack panel (2
RU, 3.5”/8.9cm.
high)
Weight: Approx. 22 lbs (10 kg)
Dimensions (including rubber feet):
Shelfmount
17”x13.5”x3.8”, 43.2cm.x34.3cm.x 9.7cm.
Rackmount 19”x13.5”x3.8”, 48.3cm. x 34.3cm. x 9.7cm.
Canada’s largest independent manufacturer of high-end audio electronics
for consumers and professionals. Founded 1962. Visit our website:
www.bryston.ca
• Audiophile sound quality and construction: all analog
gain blocks are fully discrete; premium components and
hand-matched transistors used throughout; two sepa-
rate independent linear power supplies with toroidal
transformers isolate analog and digital circuitry pre-
venting crosstalk or interference.
• Easy to use — automatically detects input signal bit-
stream type and adjusts mode.
LCD window shows
decoding and signal information and error messages;
LED indicators show button selections. Clean uncluttered
control layout.
• Flexible input management: select from 11 sources,
including 6 digital and 1 with discrete analog 5.1 input.
Toggle button switches easily between digital and ana-
log inputs.
• 6 Balanced (
XLR) outputs.
• 6.1 and 7.1 channel RCA outputs for Surround
EX™ and
DTS -
ES modes.
• Stereo and Mono down-mixing options for all surround
modes.
•Digital bass-management modes for all speaker setups.
•Bass redirection modes for any speaker set-up.
•Dynamic-limiting for late-night enjoyment of Dolby
Digital,
DTS.
•Music DSP modes: Natural, Club, Stadium, Hall,
Theatre, Church.
• Party mode (5-channel summed mono distribution for
even room-coverage) and 5-channel Stereo option
(stereo fed to front & rear).
• Easy set-up —
LCD window provides built-in menus for
speaker setup, and trim and delay adjustments, and dis-
plays error messages. Built-in test-signal generator and
test sequencer makes calibration simple.
• Individually adjustable trims and delays for each chan-
nel. Level trims may also be fine tuned using the remote.
• Each input can have preferred mode saved.
• Integrates with external control systems (
AMX, Crestron,
and others).
•Control port for external video switchers including the
Bryston
SPV-1.
•Two
12-volt trigger outputs.
•Standby Power Mode allows remote power up.
• Designed for easy upgrading to future formats.
• Hand assembly.
•Tight quality control:
100-hour test and “burn-in”
• Rugged reliable construction.
•
20-year unlimited transferrable warranty.
■ Surround Processor
5.1, 6.1, 7.1
Processes Dolby, DTS, THX, and PCM formats: Dolby
Digital, Dolby Pro Logic and Pro Logic II,
DTS-ES
Discrete 6.1, DTS-ES Matrix 6.1, DTS Neo:6, THX
Surround
EX™, THX Ultra certified, PCM 32kHz, 44kHz,
48kHz, 96kHz sample rates.
■ Audiophile Stereo Preamplifier
Digital-bypass pure analog circuit path
■ Digital/Analog Multichannel Preamplifier
Home Theatre Control Center
5.1 analog direct pass-through for DVD-Audio Players
■ DSP Processor
Ambient Surround for music
■ Stereo 24/96 D/A Converter
For high-bit PCM audio
20-YEAR WARRANTY
Unlimited, unprecedented, unequaled
Hand-held,
30-button, infrared
remote control
contains a tilt switch
and photosensor that
automatically
backlights the keys
when it is picked
up in a darkened
room.
20-YEAR WARRANTY
Unlimited, unprecedented, unequaled
SP 1.7 Technical SpecificationsSP 1.7 Key Features
Bryston Limited P.O. Box 2170, 677 Neal Drive, Peterborough, Ontario Canada K9J 7Y4 1-800-632-8217
Home Theater
Processor/Preamplifier
To Next Page
Need help?
General
