Need help?Do you have a question about the Bryston SP3 and is the answer not in the manual?
General| Channels | 7.1 |
|---|---|
| Total Harmonic Distortion (THD) | < 0.005% |
| Signal-to-Noise Ratio | > 110 dB |
| Surround Sound Formats | Dolby Digital, DTS, Dolby TrueHD, DTS-HD Master Audio |
| Outputs | 1 x HDMI |
| Frequency Response | 20 Hz - 20 kHz |
| Type | Surround Sound Processor/Preamp |
| Audio Inputs | Balanced XLR, Unbalanced RCA |
| Audio Outputs | Balanced XLR, Unbalanced RCA |
Outlines warranty terms for analog, digital, and motorized products.
Provides contact details for Bryston service in Canada, USA, and internationally.
Instructions for unpacking the unit and listing included accessories.
Refers to important safety warnings from page 2.
The dot matrix display showing graphics and alpha-numeric characters.
Buttons for navigating through menus on the display.
Buttons for display, surround modes, digital, HDMI, and 2-channel bypass.
Encoder for volume adjustment and setting parameters in menus.
Standard 1/4" jack for stereo headphones.
Buttons to select audio source for main or zone outputs.
Ten buttons to select audio input source signals.
Button to put the unit into standby mode.
Balanced XLR and unbalanced RCA analog audio outputs.
Inputs for HDMI signals; video signals are looped through.
RCA jacks for a separate stereo signal path to Zone 2.
RCA jacks for stereo input/output for tape recording.
General purpose analog input pairs.
Coaxial SPDIF and Optical TOSLINK inputs.
Contains device information and safety warnings.
Connector for the AC power cord.
RS232, Ethernet, USB, and Infrared input connections.
Balanced digital audio inputs via XLR connectors.
Unbalanced and balanced analog inputs for 7.1 surround.
Balanced XLR outputs for 7.1 + 2 surround sound.
Information on main and standby fuses, their values, and replacement procedures.
Explains the format for model part numbers.
Introduces the remote control and its basic operation.
A comprehensive list of infrared remote control codes for various functions.
Details how the remote control's backlight functions.
Configuration options for system-wide settings like speaker distances and digital sources.
Settings related to audio sources, speaker configuration, and crossover frequencies.
Details on audio conversion, DSP, frequency response, THD+Noise, S/N ratio.
Information on power consumption and standby power.
Lists analog and digital audio input/output types and quantities.
Lists serial, network, USB, and infrared connections.
Dimensions, weight, and chassis temperature limits.
Lists various trademarks used in the product and manual.
Explains various surround sound processing modes available on the SP3.
Lists command codes for controlling the SP3 via RS232.
Guide on connecting and testing the SP3's RS232 serial port.
Explains the HDMI handshake process and troubleshooting.
Instructions for connecting and using the SP3 via USB for audio streaming.
Guide to accessing and using the SP3's web-based interface.
Detailed guide on configuring subwoofer and speaker settings.
Instructions for setting up the SP3 for Local Area Network (LAN) connectivity.
Guide to configuring Dolby Volume and Dynamic Range Compression settings.
Step-by-step instructions for uploading new firmware to the SP3.
Comprehensive guide on controlling the SP3 using RS232 and TCP/IP protocols.
Instructions for performing speaker calibration using pink noise.
Explains the information displayed on the SP3's idle screen.
To Next Page
