REAR PANEL
1: SINGLE ENDED ANALOG OUTPUTS
The SP3 offers both balanced (3 pin XLR male connec-
tors [pin 2+, pin 3-] and unbalanced (RCA/phono jacks)
output connectors.
2: HDMI INPUTS
Although the SP3 uses only the audio signals carried on
an HDMI cable, the video signals are routed to the two
parallel HDMI outputs from the selected HDMI input.
3:
ZONE 2 SINGLE ENDED ANALOG OUTPUTS
A pair of RCA jacks that provide a second stereo signal
path completely separate from the main output with its
own independently selected inputs
4: TAPE RECORDER TAPE LOOP
A conventional tape loop consisting of two pairs of RCA
jacks; one stereo pair of inputs and one stereo pair of
outputs. A stereo down-mix for the selected source (or,
in 2 Channel Bypass mode, the Left and Right analog
inputs directly) appear at the TAPE OUTPUTS, unless
the selected source is the TAPE INPUT itself in which
case the TAPE
OUTPUTS are muted. The inputs can, of
course, also be used as just another pair of analog inputs,
but at unity gain only & no volume control.
5:
DIGITAL VIDEO RECORDER TAPE LOOP
A second tape loop which functions just like the Tape
Recorder Tape Loop above.
6: SINGLE ENDED ANALOG INPUTS
Four pairs of general purpose analog inputs labelled CD,
1: SINGLE ENDED ANALOG OUTPUTS
2: HDMI INPUTS
3: ZONE-2, SINGLE ENDED, ANALOG OUTPUTS
4: 1st ANALOG TAPE LOOP IN/OUT CONNECTORS
5: 2nd ANALOG TAPE LOOP IN/OUT CONNECTORS
6: SINGLE ENDED ANALOG INPUTS
7: SPDIF INPUTS
8: DATA PLATE LABEL
9: CAUTION, RECYCLING & OTHER SYMBOLS
10: IEC-320 C14 POWER INLET
To Next Page
Loading...
Need help?
General