Manual EVoBASIC v.7 46 / 80
1.3.2 Common features in all EVO equipment
Adjustment of chlorine production by switched mode power supply
Power supply performance >90%
Automatic switch-off owing to lack of water flow
Automatic switch-off owing to the accumulation of gas in the cell, with
automatic restart once the water flow is restored.
Automatic voltage adjustment depending on the concentration of salt
and the temperature, keeping continuous chlorine production.
Automatic cleaning cycle of electrodes.
Automatic restart in the event of supply failure.
1.4- Recommendations and safety precautions
The equipment should always be installed by qualified staff.
Disconnect the equipment from the mains before performing any
assembly or maintenance operation.
Make sure that the electrical installation has all compulsory protection
elements (circuit breaker and differential switch) in perfect condition.
It is important to ensure that the supply cables of the electrolysis cell are
tightly connected, otherwise the equipment could overheat and break
down.
Ensure that the heatsink wings (in the rear part of the equipment) are
not blocked and that air can easily circulate through them.
All the BSV equipment incorporate protection systems against short
circuits in the cell, absence of water detector and other safety systems
that give an acoustic and visual alarm in the event of any anomaly.
However, for optimum results, you should ensure the correct hydraulic
operation of your swimming pool.
Equipment housing has IP65 protection. However, it is highly
recommended not to install the equipment directly exposed to sunlight.
Corrosive environments may reduce the lifespan of the equipment. Do
not leave open containers with acids near the equipment.
To Next Page
Loading...