Manual EVoBASIC v.7 80 / 80
in a glass of water. If a probe has been left to dry, it can be regenerated
by leaving it for 12 hours in a glass of water, preferably adding a few
drops of hydrochloric acid.
5.4- Checking and maintenance of the Amperometric probe (PRO/2 kit)
See manual attached to the kit
6 - GUARANTEE AND SERVICE
This unit is guaranteed for a period of 3 years in control main
unit.
The electrolysis cells have a control of two years, as long as they have
not exceeded 10,000 hours of use (10K models) and 5.000 hours (5K
models).
This guarantee is given to the owner of the equipment and it
is not transferable. All chlorinators are checked at the factory before
packing. If any electrical or mechanical problems occur within 36 months
from purchase, owing to unlikely malfunctioning or to faulty components,
the parts will be repaired or changed. A part will not be changed unless
the faulty component is returned.
This guarantee does not cover damage caused by corrosion, excess
damp, current, temperature or vibration, or by incorrect installation,
unsuitable handling, overvoltage, accidents or any other cause beyond
the operation of the equipment.
In the event of an equipment failure, it should be returned to
the manufacturer or distributor. Transport costs will be covered by the
equipment owner.
It is important to bear in mind that all repairs under guarantee are
performed at the factory, or by an authorized BSV Electronic technical
service.
To Previous Page
Loading...