Manual EVoBASIC v.7 55 / 80
When this percentage is less than 100%, the chlorinator will show the
latest salt concentration value calculated and that value will remain until
the production reaches 100% again.
If the production setpoint is lower than 100%, the system will update the
salt concentration measurement during the automatic cleaning cycles,
where production will eventually reach 100%.
When the system is powered off, the latest measurement of salt will be
erased and you will see “—“ upon power on, until production reaches
100% for the first time to make the calculation again.
Important: Salt concentration measurements are trustworthy only if the
cell is in good conditions. If the cell is worn out or with overlay, the value
displayed could differ from the actual salt concentration in the water.
To Next Page
Loading...