BS POOL EVoBASIC - Page 76

Manual EVoBASIC v.7 76 / 80
4.2.1.1- Additional warning messages
ORP or PPM value is
flashing
The redox or free
chlorine probe are
balanced in automatic
mode. When the probe
is balanced,
the value
remains set.
None.
pH value is flashing
The pH probe is
balancing. When the
probe is b
alanced, the
value remains set.
None.
Value ---o (Water
temperature) is flashing
The value of the water
temperature is under
15º.
Consider the use of a
winte
r hibernator
product.
Filter time
The equipment has
swi
tched off before the
time set in semi-
automatic
Restart the filtering cycle
4.2.2- Alarm Messages
In the following cases, the chlorinator shuts down and the alarm and
acoustic alarm LED is activated (automatic reset once the fault is solved):
"NO WATER
FLOW"
Excess gas in the
electrolysis cell. It may
have occurred because the
pump has shutdown. The
gas is hydrogen gas which
is highly flammable.
The piping should be drained to
eliminate gas or accumulated
water. Check the pump.
Sensor cable of the cell is
incorrectly connected or
broken.
Check the sensor cable (white
cable)
Cell sensor is dirty.
Clean.
See maintenance.
No water flow
Check the water system
"SHORT CIRCUIT"
The cell is incorrectly
connected.
Check wiring.
Metal body in the cell.
Turn off the equipment and
remove the metal body fro
m the
plates