BSi E Series - Bracket Operation: Angle Adjustment

10/23
OWNER'S MANUAL & WARRANTY
BSI, LLC 601 East 64th Avenue, Bldg. A, Denver, CO 80229 800.662.9595 sales@bsidesigns.com bsidesigns.com
-
SERIES
AdjustaGuard
7
BRACKET OPERATION 
ADJUSTAGUARD ANGLE ADJUSTMENT
1. BSI recommends the use of two people when adjusting or performing maintenance to your
AdjustaGuard sneeze guard. Using only one person to adjust your sneeze guard may cause damage to
the brackets.
2. Hold the glass in place while loosening both handles about 1/4 - 1/2 turn. Do not remove screw or loosen
more than one full turn. Do not force the glass to rotate. If both handles are loose, the glass will move
freely.
3. Once both sides are loosened, gently rotate the glass to the desired position. Tighten both handles
before releasing the glass. Do not overtighten. Overtightening will cause the screw to strip the bracket.
4. Repeat steps 2-4 to adjust the glass angle.
SPRING-LOADED HANDLE:
The handle is spring loaded and can be
used like a ratchet when spacing does not
allow a full turn of the handle.
Loosen handle 1/4 - 1/2 of a rotation.
Tighten handle after desired angle is
achieved.