To Next PageTo Next PageWhy is the BSi Indoor Furnishing heat inadequate?
If the BSi Indoor Furnishing unit isn't providing enough heat, there could be several reasons. First, the unit might be mounted too high; try lowering it. Second, excessive air movement might be interfering; restrict or redirect air movement away from the unit. Finally, the power supply might be incorrect. Ensure it matches the unit's rating, and change it if it doesn't.
Why is the BSi Indoor Furnishing heat excessive?
If the BSi Indoor Furnishing unit is producing too much heat, it could be due to several factors. Check that the installation is within recommended specifications, as the unit might be too close to the target area. Also, ensure the power supply matches the unit's rating; correct it if it doesn't. If these steps don't solve the problem, consider adding a remote infinite switch to control the heat.
What to do if BSi Indoor Furnishing is on but there is no heat?
If your BSi Indoor Furnishing unit is on but not producing heat, the issue might stem from a lack of power. Check the circuit breaker and reset it if necessary. It could also be a defective switch, in which case you should contact an Authorized Service Agent or BSI for assistance.
How to prevent control switches from burning out in BSi Indoor Furnishing?
General| Brand | BSi |
|---|---|
| Model | E Series |
| Category | Indoor Furnishing |
| Language | English |
General safety guidelines for AdjustaGuard food guards. Installation and hazards.
Procedures for checking delivered AdjustaGuard food guards for damage and completeness.
Overview of different AdjustaGuard food guard models and their visual identification.
Identifies and illustrates the main parts of the AdjustaGuard food guard system.
Details the assembly of AdjustaGuard brackets and lists all component parts with numbers.
Instructions on how to adjust the angle of the AdjustaGuard glass using the spring-loaded handle.
Guide for adjusting the height of the AdjustaGuard glass using thumb screws and hex screws.
Table detailing permissible load limits for different glass thicknesses and span widths.
Information about end panels for AdjustaGuard, their parts, and NSF requirements.
Illustrations and details for various mounting configurations for 1" round posts.
Illustrations and details for various mounting configurations for 1" round posts.
Diagrams and details for various mounting configurations for 1" square posts.
Illustrations and specifications for various mounting configurations for 1-1/2" square posts.
Details various mounting configurations for 2" square posts, including specific flanges and trim rings.
Precautions to prevent electrical shock, including proper grounding and handling of cords.
Guidelines for maintaining safe distances from combustible materials to prevent fire.
Safety measures regarding flammable substances and proper food heating procedures.
Procedures for checking Helios light and warmer units upon delivery for damage and completeness.
Identification of the Helios Light/Warmer Combo Unit Model 705E.
Step-by-step guide on how to safely replace the LED bulb in Helios units.
List of part numbers and descriptions for ordering replacement LED light bars.
Information on where to find the product identification sticker and its contents.
Catalog of part numbers and specifications for tubular heating elements for Helios units.
Information on obtaining service and replacement parts for Helios units.
Diagrams illustrating the electrical connections for Helios light and warmer combo units.
Details the warranty coverage for E-Series food guards against defects for one year.
Outlines the warranty for Helios housing, warming element, and ballast for one year.
