10/23
OWNER'S MANUAL & WARRANTY
BSI, LLC 601 East 64th Avenue, Bldg. A, Denver, CO 80229 800.662.9595 sales@bsidesigns.com bsidesigns.com
AdjustaGuard
9
SADDLE
THREADED PIN
WASHER
NUT
END PANEL
• Wipe the surface with a clean, damp cloth to remove fingerprints, dust, etc.
• Spray with a light coating of glass cleaner to remove grease and dirt. Use a non-ammonia cleaner.
• Do not use brass polish on your food guards as it will degrade the finish.
• Do not scrub the surface with abrasives like steel wool, pot scrubbers, abrasive powders, or similar
products as they will remove the protective coating.
• If unit is fitted with a warmer, do not clean the glass or housing when warmer is hot. Cleaning warmer
when hot can cause staining or damage to warmer finish.
CLEANING INSTRUCTIONS
END PANELS
To meet NSF guidelines, end panels are included on all BSI
quotations unless otherwise specified.
Location Part # Part Name
9 336 Decorative Nut
10 484 Clear Mylar Spacer
11 15756 End Panel Bracket Assembly
12
1/4-20 x 1-1/4" Machine Screw Flat Phillips
NSF End Panel Requirement Exemption
NSF/ANSI Standard 2 - 2018
5.36.1.6.2 A food shield intended to be installed a maximum of 3 inches (76 mm) from a building wall
perpendicular to the food shield is exempt from the requirements of 5.36.1.6.1 provided that the height of
the building wall is not lower than the overall height of the food shield. The manufacturer's specification
sheet, brochure, installation instructions, and/or shop drawings shall include these building wall and
proximity requirements.
To Next Page