Need help?Do you have a question about the BSS Audio FDS 310 and is the answer not in the manual?
Explains connecting signal sources via 3-pole (stereo) or 2-pole (mono) phone plugs.
Details wiring for balanced/unbalanced sources using female XLR connectors.
Describes connecting balanced outputs using 14" phone plugs and phasing.
Explains connecting balanced outputs via male XLRs and handling unbalanced inputs.
Guides stereo 2-way setup, including I/O connections and crossover adjustment.
Describes the green 'SIGNAL' LED indicating signal presence and illumination.
Explains the red 'PEAK' LED indicating signal levels near overload or clipping.
Details internal switches for sub-woofer operation, including 'divide by 10' frequency setting.
Explains activating mono mode for sub-woofers using a 3-pin programming plug jumper.
General| Input Connectors | XLR |
|---|---|
| Output Connectors | XLR |
| THD | < 0.01% |
| Dynamic Range | > 110 dB |
| Mute | Yes |
| Phase Invert | Yes |
| Power Supply | 100-240V AC, 50/60 Hz |
| Frequency Range | 20Hz - 20kHz |
| Weight | 6.6 lb (3 kg) |
| Slope | 12 dB/octave |
| Dimensions | 19" x 1.75" x 8.5" (483mm x 44mm x 216mm) |
To Next Page
