Need help?Do you have a question about the BST ekr 500 Plus and is the answer not in the manual?
General| Brand | BST |
|---|---|
| Model | ekr 500 Plus |
| Category | Controller |
| Language | English |
Describes the assembly and commissioning of the web guiding system ekr 500 Plus with CLS Pro 600.
Defines the relationship between selection buttons and sensors for guiding mode.
Details on setting DIL switches (S4.4 to S4.8) for actuator and servo-center selection.
Guides the initial setup and configuration of the EMS actuator components.
Checks the assignment of arrow keys to actuating direction (motor rotation) of the actuator.
Setting guiding direction for line or contrast guiding on the CLS Pro 600 sensor.
Specific setup procedures for actuators lacking position feedback.
Procedure for adjusting the gain of servo-center components for stable guiding operation.
Specific setup procedures for actuators with position feedback.
Checks guiding direction for servo-center mode with position feedback actuators.
Adjusts software limit switches and servo-center position using a special setup menu.
Explains the display area colors indicating different operating modes (AUTOMATIC, MANUAL, SETUP, Error).
Specifies controller mode (MAN) and correct sensor-to-material distance for setup.
Procedure to log in as Administrator to access sensor setup and configuration parameters.
Teaches the sensor's mounting position via a 4-step procedure, starting with manual positioning.
Instructions on switching the controller to MAN operating mode via the controller keyboard.
Procedure for selecting MAN operating mode on the sensor using arrow keys and ENTER.
Guides through setting up the sensor for edge detection, involving positioning and confirmation.
Guides through setting up the sensor for line detection, involving positioning and confirmation.
To Next Page
