Need help?Do you have a question about the BST ekr CON 600 and is the answer not in the manual?
General| Brand | BST |
|---|---|
| Model | ekr CON 600 |
| Category | Controller |
| Language | English |
Information on the Master-Slave Guiding function and its relation to the main operating manual.
Identifies the intended audience for these instructions.
Guidelines for storing and distributing the manual.
Explanation of safety levels (DANGER, WARNING, CAUTION, NOTICE) and operational symbols.
Illustrates symbols used to indicate key operations on the controller.
Guidance on accessing other related documents and the latest manual versions.
Defines the specific purpose of the Master-Slave Guiding with Sensor Positioner.
Describes uses that are not permitted for the web guiding system.
General safety instructions for users operating the system.
Explains how the Master-Slave Guiding with Sensor Positioner operates.
Details the different guiding modes available for the system.
Describes the ekr CON 600/net controller and its requirements.
Explains the function of the guiding device in correcting web position.
Details the FVG POS 100 sensor positioners and their requirements.
Critical safety warnings related to electrical connections and voltage.
Details on connecting cables and required accessories.
Details connector assignments for the ekr CON 600/net controller.
Connector assignment for four edge sensor setups, including edge/center-line guiding.
Details the terminal assignment for connection sensor 4.
Safety warnings for commissioning, including hazards from moving parts.
Prerequisites for system commissioning, including wiring and locking devices.
Procedure to enable Master-Slave Guiding using the DIL switch S6.6.
Steps for setting up the material to ensure optimal guiding results.
Instructions on accessing the sensor positioner setting menus.
Details the functions available in the SLAVE and MASTER setting menus.
Configures sensor slides to return to park position on mode change.
Enables automatic edge detection for setting guiding setpoints.
Defines hysteresis for sensor tracking with 'flattering' web edges.
Calibrates optical sensors for transparent materials.
Sets an absolute reference point for sensor slide positions.
Safety precautions for operating the web guiding system and avoiding hazards.
Step-by-step guide to activating and starting the Master-Slave Guiding.
Explains the sensor symbols and their meaning on the controller display.
Identifies situations requiring a material setup for optimal guiding.
Compares manual and automatic material setup procedures.
Illustrates the procedure for capturing bright and dark values.
Details how to activate manual or automatic material setup via the controller.
Procedure for saving bright/dark values using automatic material setup.
Procedure for saving bright/dark values with critical contrasts using manual setup.
Provides contact information for ordering BST products.
Lists available accessories and their utilization.
Wiring diagram for guiding to the left web edge with two edge sensors.
Wiring diagram for guiding to the right web edge with two edge sensors.
Wiring diagram for edge/center-line guiding with ekr CON 600 controller.
Wiring diagram for edge/center-line guiding with ekr CON 600 net controller.
To Next Page
