BST PB2 Series - Installation; Preparation Tools and Safety Gear

BST Power (Shenzhen)
Limited
18
2
Power cable
L=2.0m / 4AWG / 120A / Red and Black / UL1015
3
Cascade
communication
cable
L=1.0m
4
Cascade
communication
cable
L=2.0m
4 Installation
4.1 Preparation before installation
a. The following tools are required to install the PB2:
Tape measure Pencil Cross screwdriver
Multimeter Percussion drill (M8) Adjustable wrench
b. When handling the PB2, It’s required to wear the following safety gears:
NOTICE
Use properly insulated tools to prevent accidental electric shock or short
Insulated gloves Safety goggles Safety shoes