Need help?Do you have a question about the BST PB2 Series and is the answer not in the manual?
Specifies the valid PB2 series models for the document.
Describes the document's coverage of PB2 series products.
Identifies qualified personnel for performing manual instructions.
Explains the different warning message levels (DANGER, WARNING).
Defines notice types and lists manual abbreviations.
Provides a critical DANGER warning before product use.
Details the nameplates and warning labels on the PB2.
Emphasizes installer's responsibility to understand manual contents.
Lists essential safety measures to be observed during operation.
Lists critical dangers: explosion, fire, electric shock, and damage.
Guides on proper PB2 operation and communication address setup.
Outlines precautions like avoiding defects, disassembly, and improper environments.
Provides guidelines for fire, wading, and damaged battery emergencies.
Introduces PB2 series as LiFePO4 battery storage systems.
Lists key features like LiFePO4 chemistry, scalability, and inverter compatibility.
Introduces the technical data section for PB2 series.
Shows diagrams of PB2-5.1 and PB2-10.2 dimensions.
Details general and electrical performance specs for PB2 models.
Lists operating parameters like temperature, humidity, altitude, and IP rating.
Identifies and illustrates the various ports and interfaces on the PB2.
Describes the function of each main component and port.
Explains how the display panel indicates normal and alarm states.
Details display descriptions for different operating modes and indicator lights.
Explains DIP switch positions and provides a table for setting communication addresses.
Defines the pin configurations for the RJ45 ports on the battery.
Lists the items included in the standard package for PB2-5.1/10.2.
Lists available optional accessories for the PB2 series.
Lists required tools and safety gear for PB2 installation.
Specifies environmental and location requirements for installing the PB2.
Outlines physical constraints and wall strength for installation.
Provides dimensional drawings for PB2-5.1 and PB2-10.2 mounting brackets.
Shows required clearance around the battery for installation and ventilation.
Provides instructions for handling and transporting the PB2 during shipment.
Advises on safe handling and lifting of heavy PB2 units.
Details initial installation steps like unpacking and fixing rubber pads.
Illustrates mounting bracket installation with respect to the ground.
Guides on marking the wall for drilling mounting bracket holes.
Explains drilling holes and inserting M8-70 screws for mounting.
Details how to fix the mounting bracket securely to the wall.
Describes how to hang or buckle the PB2 onto the installed mounting bracket.
Outlines the steps for performing a self-test after installation.
Explains wiring and communication setup for a single PB2 unit.
Details wiring and communication setup when using multiple PB2 units.
Step-by-step guide to powering on the PB2 system.
Step-by-step guide to safely powering off the PB2 system.
Addresses issues with communication between PB2 and inverter (RS485/CAN).
Troubleshoots problems related to the PB2 failing to turn on.
Diagnoses and resolves issues where the battery cannot be charged.
Addresses issues preventing the battery from discharging.
Provides solutions for error code E9 related to temperature.
Recommends periodic cleaning using appropriate methods.
Specifies environmental conditions and time for storing the battery module.
Guides on complying with local regulations for waste disposal.
Explains the limited warranty and conditions that invalidate it.
Lists reasons for which BST is not liable for damages or defects.
To Next Page
General