3 Connect your device
If the connection is successful, connect your device to the broadband
extender using the ethernet cable provided.
After 1 minute of inactivity on the ethernet port, the extender will go into power
save mode. The Power indicator will be flashing.
Light status
Light Status What’s happening
Power On Extender running normally
Flashing Extender resetting, synchronising or power save mode
Off Extender turned off
Ethernet On Device connected to extender
Flashing Data being sent or received
Off No device connected to extender or device switched off
Data On Extender connected to network
Green: High transfer speed
Orange: Medium transfer speed
Red: Low transfer speed
Off No connection to network
Broadband Extender
Data
Ethernet
Power
To Next Page
Loading...
