If you need some help, call us on 0800 218 2182* or go to bt.com/producthelp
39
You can register up to five GAP
compliant handsets to your
BT1200 base to extend your
phone system without needing
to install telephone extension
sockets for each new phone.
If a handset becomes
un-registered it will need to be
registered to the base again.
If registration isn’t successful
the first time, please try again
in case the base registration
period ran out of time.
If there are already five
handsets registered to the
base, the registration will fail.
You must de-register another
handset before you can register
the new one.
If you’ve bought a BT1200 multiple pack, any
additional handsets come pre-registered to the
base. However, if you purchase an additional
handset separately, you must register it to your
BT1200 base before it can be used.
Register an additional handset
1. Press and hold the
button on the base for 5
seconds. The base is entered into registration mode.
You will hear a confirmation tone.
2. Press
, scroll to
REGISTRATION
and press .
3. Enter the 4 digit PIN and press
. The default
system PIN is 0000.
4. Once registration is successful the handset will
show
HANDSET
X
(with X being the next assigned
handset number).
Using additional handsets
To Next Page
Loading...
Need help?
General
