If you need some help, call us on 0800 145 6789* or go to bt.com/producthelp
19
When you make a call,
the In use light on the base
comes on.
Auto end
By default, auto end is set to On
and you can end a call just by
putting the handset back in the
base. If auto end is set to Off,
you’ll need to press to end
the call. See page 53.
To switch the handset off
1. Press and hold until the handset turns off.
To switch the handset on
1. Press and hold until the handset turns on.
Make an external call
1. Press .
2. When you hear the dial tone, enter the number.
Preparatory dialling
1. Enter the number first. If you make a mistake select
Del.
by pressing the Right option button to
delete the last digit.
2. Press to dial.
End a call
1. Press .
Using the phone
Call timer
Your handset will automatically
time your outgoing and
incoming calls. The handset
shows the length of time both
during and for a few seconds
after your call.
If you switch the phone off
and on again, the phone will
need to be charged for some
time, before the true charge
status can be recalculated
by the phone and accurately
displayed.
To Next Page
Loading...
