BT REFLEX RR B1-3 - 37.2 Checking the fork carriage’s wearing strips

T-code Valid from serial number
403-414, 669-671, 716-718 713962-
Date Order number
2005-06-01 218920-040
37- 4 Service Manual REFLEX RR B,E RR B,E CC © BT Europe AB
Lifting devices – 7400
Checking the fork carriage’s wearing strips
37.2 Checking the fork carriage’s
wearing strips
The wearing strip (A) between the yoke and ball beam on the fork car-
riage is exposed to wear and must be checked every year. Measure the
space (B) between the yoke and the ball beam.
When the wearing strip is new, the space is 2 mm.
If the space is 4 mm or more, the wearing strip must be replaced.
Check the space (C) between the stop lug and the fork yoke on the fork
carriage as well.
Max. tilt angle up to 1 mm.
The space can be adjusted using the screws on the stop lug.
A
B
C
https://www.forkliftpdfmanuals.com/