Valid from serial number T-code
713962- 403-414, 669-671, 716-718
Order number Date
218920-040 2005-06-01
© BT Europe AB Service Manual REFLEX RR B,E RR B,E CC 4- 3
Introduction, maintenance – P1
Safe lifting
4.2.1 Cleaning the exterior
• Remove rubbish, etc. from the wheels daily.
• Use a well-known degreasing agent, diluted to a suitable concentra-
tion.
• Rinse off loose grime using tepid water.
NOTE!
Jamming, corrosion
Mechanical parts can be damaged.
After washing the truck it should be lubricated as set out in the chap-
ter Maintenance and the lubrication chart C-code P2.
4.2.2 Cleaning the motor compartment
• Cover the electric motors, connections and valves before washing.
NOTE!
Risk of short-circuiting.
The electrical system can be damaged.
Electrical components must not be washed with high-pressure clean-
ers.
• Clean the motor compartment using a well-known degreasing
agent, diluted to a suitable concentration.
• Rinse off loose grime using tepid water.
4.2.3 Electrical components
• Blow electric motors clean using compressed air.
• Clean electrical panels, electronic boards, contactors, contacts, so-
lenoid valves, etc. using a damp cloth and a cleaning agent.
NOTE!
Risk of short-circuiting.
The electrical components can be damaged.
Do not break the warranty seal on the electronic card.
4.3 Safe lifting
All lifting must be carried out on a flat, anti-slip and firm surface. Avoid
newly-laid asphalt or asphalt on a hot summer’s day.
• Activate the parking brake to prevent the truck from moving during
lifting. If the lift applies to the brake wheel, chock the other wheels so
that the truck remains still.
• Select the lifting points so that the lift is as easy as possible (one cor-
ner at a time). If the truck has marked lifting points on the under side
of the chassis these can be used to achieve well-balanced lifting.
https://www.forkliftpdfmanuals.com/
To Next Page
Loading...