Valid from serial number T-code
713962- 403-414, 669-671, 716-718
Order number Date
218920-040 2005-06-01
© BT Europe AB Service Manual  REFLEX RR B,E RR B,E CC 37-  7
Lifting devices – 7400
Telescopic forks
37.4  Telescopic forks
37.4.1 Telescopic forks
The KOOI forks, manufactured by Meijer Special Equipment Company 
in Holland
 (BT has the right to use original text from Meijer Special Equipment in the 
Netherlands, which is the manufacturer of KOOI Reachforks.)
, are a specially-
designed fork with a thickness of 56 mm. This flatter fork can be used 
for load bearers with lower tunnel heights. The telescopic forks are fit
-
ted just like conventional lifting truck forks and can be moved on the 
carriage in the same way. Each fork has an identification plate on the 
top. The plates contain important information about the technical spec
-
ifications of the fork, for example, the maximum load capacity per fork.
Operation of the telescopic forks is by means of a closed and self-lubri-
cating oil circuit. The telescopic forks are delivered with oil that com-
plies with cleanliness standard ISO 4406 17/12.
The telescopic forks should be re-tested every year according to the 
ISO 5057 requirement (See chapter 1.1). The international standard 
has to be applied for checking the forks except for the chapters regard
-
ing “Fork arm blade and shank” because the inner fork must not be 
exposed to wear
An L or R is added to the identification plates of the telescopic forks . 
The forks are mounted on the fork carrier corresponding to left and right 
as viewed from the driver’s seat. The forks slide onto the fork carrier so 
that the locking catch fits into the carrier recess.
The flow divider is mounted on the back of the fork carrier.
The flow divider is mounted in a horizontal position.
The hydraulic hoses included for the telescopic forks and the hoses for 
the forklift truck are connected according to the figure.
Every fitting must be carefully tightened and secured.
The maximum fluid pressure of the telescopic forks is 200 bar.
https://www.forkliftpdfmanuals.com/