T-code Valid from serial number
403-414, 669-671, 716-718 713962-
Date Order number
2005-06-01 218920-040
9- 2 Service Manual REFLEX RR B,E RR B,E CC © BT Europe AB
Driver protection – 0840
Tilt Stops
9.2 Tilt Stops
9.2.1 Inspection and Adjustment
To ensure safe operation of the truck, it is important to check the space
between the tilt stops and the floor regularly.
• Park the truck on a flat surface.
• Measure the distance between the tilt stop and the floor (max. 15
mm).
.
• If the tilt stop scrapes the floor or if the distance is too great, the lugs
must be adjusted.
• Lift up the rear edge of the support arm using a jack and place a
wooden block under the support arm to prevent the truck from top
-
pling over.
• Break the seal.
• Remove the bolts and washers.
• Re-shim the stop so that the distance between it and the floor is as
close to 15 mm as possible. However, the distance must not exceed
15 mm. Each shim is 4 mm.
• Fit the remaining shims between the tilt stop and the bolt's washer.
• Refit the bolts and washers.
• Using a torque wrench, tighten bolts to 77.7 Nm.
• Seal
https://www.forkliftpdfmanuals.com/
To Next Page
Loading...